![]() ![]() The VDogGateway service communicates using the standard 102 port (RFC1006). The VDogGateway.ini file is valid for different application situations and must therefore be edited for each controller. installation files\ versiondog \VD$A\Configuration.Ĭonfigure the VDogGateway.ini file using the following parameters: Open the file VDogGateway.ini that was created during the installation in. \installation files\ versiondog \tools\vdoggateway). To install the versiondog Gateway double-click on the VDogGateway.exe file (path to the file. The versiondog gateway is usually installed on the PCU of your SINUMERIK 840D.When configured correctly, the gateway can complete a wide range of tasks (for example, establish the communication to versiondog Agents and a gateway for versiondog clients).A gateway operating between two different network types is not required to have a license (for example, TCPIPMPI, TCPIPProfibus, TCPIPProfinet). ![]() A gateway operating between two TCP/IP networks will require a license. ![]() A maximum of one gateway can be active on a single computer. ![]() Image: Gateway installation for a SINUMERIK 840D solutionline with a configured INI file. In this situation, you need to install the versiondog Gateway on the PCU (HMI-PC). If your SINUMERIK system is only connected to the internal machine network, then the NCU for versiondog is only accessible through the PCU (HMI-PC). You are here: SINUMERIK 840D HMI Advanced: Installing and configuring the Gateway ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |